Electric Garage Heaters: 120V vs 240V, Wattage, Circuit
Posted by MN Garage Notes Editorial Team Reviewer: MN Garage Notes Editorial Team Most recently reviewed Published In Garage heating
Electric garage heaters turn electricity into heat at about 3.41 BTU per hour per watt, so a 5,000 W unit is roughly 17,000 BTU per hour. Larger units usually need a dedicated 240 V circuit sized to the nameplate, which is electrician work. Keep 3 feet of clearance, avoid extension cords and keep flammable liquids away.
Belongs to the guide: Garage Heaters: Types, Sizing and Safety
Electric units are one family in our heater types; this page covers how they work, the watts-to-BTU conversion and the circuit questions.
Background reading only. Treat it as no stand-in for your owner’s manual, the maker’s install sheet, your local building and fire code, or a licensed tradesperson. A garage can hold carbon monoxide, open flame, live circuits, wound springs and solvent fumes. The Garage Notes team checked each claim against the sources listed on this page; it holds no trade licence.
Safety block: consult your owner’s manual
Electric garage heaters make no combustion gases, but they are a fire risk if clearances, cords or flammable vapors are ignored. Read the owner’s manual before installing or using one. NFPA says to keep a space heater at least 3 feet from anything that can burn, including people, to plug it directly into a wall outlet and never use an extension cord, and to turn it off and unplug it when you leave the room or go to bed. A manual we opened says not to use the heater where gasoline, paint or flammable liquids are used or stored. For details, see garage heater safety: CO and clearances.
How electric garage heaters work
Electric garage heaters turn electricity into heat; the main styles are fan-forced, ceramic, oil-filled and infrared. NFPA’s tip sheet describes types: oil- or water-filled radiators, fan-forced heaters that blow air over metal coils, ceramic heaters and infrared heaters that create heat with infrared bulbs. For garages, fan-forced hardwired units with a built-in thermostat are common; one data sheet we opened describes a garage/shop unit with a thermostat range of 40 to 85 degrees F, wall or ceiling mounting at least 6 feet above the floor, and a thermal overload that disconnects the elements if normal operating temperatures are exceeded. Radiant types are covered in infrared garage heaters.
| Style | How it heats (NFPA) | Typical connection | What to check |
|---|---|---|---|
| Fan-forced | A fan blows warm air over metal coils | Plug-in 120 V or hardwired 208/240 V | Clearances, circuit size, thermostat |
| Ceramic | Air is warmed over a ceramic heating element | Usually plug-in | Wall outlet only, no extension cord |
| Infrared | Heat is created by infrared bulbs | Plug-in or hardwired | 3 feet from combustibles |
| Oil or water-filled radiator | Heated oil or water travels through the heater | Plug-in | Flat solid surface, tip-over shut-off |
Match the style to your circuit and use pattern, then confirm clearances and wiring in the manual.
Watts to BTU
Every watt of electric heat is about 3.41 BTU per hour, so a 5,000 W heater delivers roughly 17,000 BTU per hour. One manufacturer’s table lists 5,000 W at 17,065 BTU per hour and 7,500 W at 25,598 BTU per hour, which is 3.413 BTU per hour per watt. Use that factor when you compare an electric heater against the heat load from the heater sizing tool. The heat load itself depends on your insulation; see sealing and insulating the garage.
120 V plug-in versus 240 V hardwired
Plug-in 120 V heaters are limited by the outlet circuit and are usually smaller; larger garage heaters are typically 208 or 240 V and hardwired to their own circuit. Manufacturers list their heaters at several wattages and voltages. One data sheet pairs 240 V models with 14-gauge wire and a 15 amp two-pole breaker (2,850 W), 12-gauge wire and a 20 amp breaker (3,850 W), and 10-gauge wire and a 30 amp breaker (5,000 W). Treat those as examples from one product line; the nameplate, the installation manual and the electrical code adopted in your area set the wire, breaker and any conduit.
Circuit and breaker: when to hire an electrician
A new 240 V circuit or heater hookup is electrician and permit territory. One unit heater manual we opened says all wiring must follow national and local codes, that the heater must be grounded, that supply voltage must match the nameplate, and that circuit breakers must be sized per the national electrical code. It also says to use copper wire rated at least 75 degrees C and not aluminum with that unit, and that conduit may be required. This site gives no panel-internal steps. If you are unsure, stop and hire a licensed electrician.
Thermostats and controls
A thermostat and overheat protection are features NFPA lists as part of a safe heater checklist. NFPA’s checklist also includes a tip-over shut-off, a seal from a qualified testing laboratory and placement on a solid, flat surface. One manual we opened includes a red alarm light that shows the heater has turned off from overheating and says not to operate the heater with the light on; check the manual for what your unit’s indicators mean.
Running cost: use the formula
Cost per hour equals kilowatts times your price per kilowatt-hour. A 5,000 W heater is 5 kW, so one hour at full output uses 5 kWh. Multiply by the rate on your own bill. This page quotes no cost figure because no dated primary price source was opened. A thermostat means the heater does not run at full power all the time, so your real cost depends on how well the garage holds heat.
Safety: cords, tip-over, clearances and GFCI
- No extension cords or power strips for portable heaters (NFPA, CPSC).
- Keep the heater on a solid, flat surface and out of foot traffic. Never block an exit (NFPA).
- Keep children away; NFPA recommends a 3-foot kid-free zone around space heaters.
- Keep clearances from the manual. One we opened requires 36 inches to any object in front and a minimum mounting height of 6 feet.
- GFCI: whether your local electrical code requires GFCI protection for garage outlets or heater circuits is a code question this page does not answer; ask your electrician or building department.
- Do not leave portable units running unattended; turn them off when you leave or go to bed.
Related pages
| Style | How it heats (NFPA) | Typical connection | What to check |
|---|---|---|---|
| Fan-forced | A fan blows warm air over metal coils | Plug-in 120 V or hardwired 208/240 V | Clearances, circuit size, thermostat |
| Ceramic | Air is warmed over a ceramic heating element | Usually plug-in | Wall outlet only, no extension cord |
| Infrared | Heat is created by infrared bulbs | Plug-in or hardwired | 3 feet from combustibles |
| Oil or water-filled radiator | Heated oil or water travels through the heater | Plug-in | Flat solid surface, tip-over shut-off |
Match the style to your circuit and use pattern, then confirm clearances and wiring in the manual. Hardwired 240 V units are electrician work.
Frequently asked questions
What size electric heater do I need for a 2 car garage?
It depends on insulation, air leaks, climate and target temperature, so no single wattage fits every 2-car garage. Use the garage heater size calculator to estimate the heat load in BTU per hour, then convert: each watt is about 3.41 BTU per hour. Check the heater manual for coverage limits, and insulate first to lower the load.
Can I plug a garage heater into a regular outlet?
Some small 120 V heaters are designed to plug in, and NFPA says to plug portable heaters directly into a wall outlet, never an extension cord or power strip. Larger garage heaters are typically 208 or 240 V and hardwired. Check the nameplate and manual for the voltage and circuit, and ask an electrician if the outlet is shared with other loads.
How much does it cost to run an electric garage heater?
Multiply the heater's kilowatts by hours of use and by your price per kilowatt-hour. A 5,000 W heater is 5 kW, so one hour at full output is 5 kWh. This page quotes no dollar figure because no dated primary price source was opened. A thermostat reduces run time once the garage is warm.
Do 240V heaters need an electrician?
In most cases yes. A 240 V heater is hardwired to a dedicated circuit with correctly sized wire, breaker and grounding, and one manufacturer's manual says wiring must follow national and local codes. Permit rules vary by location. If you are not trained in electrical work, hire a licensed electrician rather than guessing.
Are electric garage heaters safe to leave on?
Do not leave portable electric heaters running unattended or overnight. NFPA says to turn them off and unplug them when you leave the room or go to bed. Fixed, thermostat-controlled heaters may be built for longer runs, but only the manual can say so. Keep clearances and flammable liquids away either way.
Sources and further reading
- NFPA: Electric Portable Space Heater Safety tip sheet (PDF) (content.nfpa.org)
- NFPA: Heating Safety tip sheet (PDF) (nfpa.org)
- CPSC: Keep Warm and Safe This Winter (2026 release) (cpsc.gov)
- Example manufacturer manual: FUH Series electric unit heater installation, operation and maintenance instructions (PDF) (marleymep.com)
- Example manufacturer data sheet: EKB Series garage/shop electric heater (PDF) (king-electric.com)
- U.S. Department of Energy: Home Heating guide (PDF) (energy.gov)
- USFA: Heating Fire Safety (usfa.fema.gov)
Related articles
- Garage Heaters: Types, Sizing and Safety
Compare electric, natural gas and propane garage heaters by venting, carbon monoxide risk, clearances and who must install them, with sources cited.
- Garage Heater Safety: CO, Clearances and Fire Risk
Garage heater safety explained from CPSC, CDC, NFPA and USFA sources: carbon monoxide, clearances, flammable vapors, alarms and what never to do.
- Natural Gas Garage Heaters: Vented Unit Heaters Explained
Vented natural gas unit heaters in a garage: venting, combustion air, one manual's 18-inch burner height and why a licensed pro must install.
- How to Heat a Garage: Options, Sizing and Cost Factors
How to heat a garage in order: insulate and seal, find the heat load, pick a heater type, and follow the carbon monoxide and clearance rules.
- Infrared and Radiant Garage Heaters Explained
Infrared and radiant garage heaters explained: electric versus gas-fired types, 3-foot clearances, manual mounting rules and fire safety near vapors.
- Propane Garage Heaters: Safety, Venting and Sizing
Propane garage heater safety, venting and sizing basics from CPSC, NFPA and DOE: vented versus unvented units, CO risk, cylinders and who should install.